RC Time Constant Calculator
Enter the resistance and capacitance to find the time constant τ, how long the capacitor takes to charge to 63% and 99%, and the -3 dB cutoff frequency.
| Time constant τ (to 63.2%) | 1 s |
|---|---|
| Time to 99% | 4.6052 s |
| Five time constants (99.3%) | 5 s |
| Cutoff frequency | 0.159155 Hz |
| τ in readable units | 1 s |
Link to this calculation – copied!
Formula
V(t) = Vs × (1 − e−t/τ)
t99% = τ × ln(100) ≈ 4.6 τ
fc = 1 ÷ (2π × R × C)
| Symbol | Meaning |
|---|---|
| τ | Time constant, in seconds |
| R | Resistance, in ohms |
| C | Capacitance, in farads |
| Vs | Supply (step) voltage |
| fc | Cutoff frequency of an RC filter, in hertz |
How to Use This Calculator
- Enter the Resistance (kΩ).
- Enter the Capacitance (µF).
- Press Calculate. Results also update automatically as you type.
Worked Example
Using the values pre-filled in the calculator above:
| Resistance | 10 kΩ |
|---|---|
| Capacitance | 100 µF |
| Time constant τ (to 63.2%) | 1 s |
|---|---|
| Time to 99% | 4.6052 s |
| Five time constants (99.3%) | 5 s |
| Cutoff frequency | 0.159155 Hz |
| τ in readable units | 1 s |
About This Calculation
When a capacitor charges or discharges through a resistor, the voltage does not change linearly but follows an exponential curve. The time constant τ (tau), equal to R × C in seconds when R is in ohms and C in farads, sets the speed of that curve. After one τ a charging capacitor reaches about 63.2% of the supply voltage; a discharging one falls to 36.8% of its starting value.
Each further time constant closes 63.2% of the remaining gap: about 86.5% after 2τ, 95% after 3τ, 98.2% after 4τ and 99.3% after 5τ. Engineers usually treat a capacitor as fully charged after five time constants. Reaching exactly 99% takes ln(100) ≈ 4.6τ. A 10 kΩ resistor with a 100 µF capacitor has τ = 1 second.
The same RC pair forms a simple low-pass or high-pass filter, with a cutoff frequency of 1/(2πRC) at which the signal is reduced by 3 dB (to about 70.7% of its amplitude). RC timing is used for switch debouncing, power-on reset delays, 555 timer circuits and smoothing PWM signals. Real electrolytic capacitors have tolerances of ±20% or more, so treat calculated times as approximate.
Frequently Asked Questions
- Why 63% for one time constant?
- The charging curve is 1 − e−t/τ. At t = τ this equals 1 − 1/e ≈ 0.632, so the capacitor is 63.2% of the way to the supply voltage.
- Is a capacitor ever fully charged?
- Mathematically the curve never quite reaches 100%, but after 5τ it is within 0.7%, which is fully charged for practical purposes.
- How much energy does the charged capacitor hold?
- Use the capacitor energy calculator, which applies E = ½CV².